Tips To Extend the Life of Your Car 2

Car Exterior
22. Protect car paint from the sun
Paint does more than make your vehicle look great. It’s also the first line of defense against rusted body panels. Of course, the best way to protect the paint is to park the car in a garage. If that is not possible, park in the shade or purchase a car cover. The sun’s ultraviolet rays break down paint and cause it to fade. Some car covers protect your car from more than sun, moisture, bird droppings, and dust — they also have a thin layer of cushioning that will guard against light impact, such as from a tipped bicycle or small falling tree branch.
23. Touch up nicks sooner rather than later
Touch-up paint won’t adhere well to rust. So be sure to keep some matching touch-up paint on hand so you can touch up any minor nicks, often found around door edges, before rust has a chance to form.
24. Tape saves light covers
A cracked taillight or turn-signal cover, if left alone, may allow your light compartment to fill with water and cause some real damage. A good short-term fix is to tape over the crack. Use the red or orange tape that’s made for this purpose.You can purchase it at many automotive parts stores.
25. Avoid light fixture problems
When changing a bad bulb, clean dirty or corroded sockets with fine steel wool or a small wire brush.Wipe the socket clean of debris before installing the new light bulb.
26. Fix small windshield chips
Got a rock chip, crack, or ding in your windshield? Bring your car to a windshield repair shop. For far less cost than replacing the windshield, they can fix chips and cracks, even quite long ones. The repairs not only keep the chips and cracks from spreading and restore structural integrity, they also improve clarity.
27. Fill with washer fluid only
Don’t add water to the windshield washer reservoir. It won’t clean as well as washer fluid, and it may freeze in cold weather and damage the system. Don’t try to run your windshield washer system once you suspect there’s no more fluid in the tank, or you may damage the washer fluid pump.
28. Fix the washer fluid tank
Cracked washer-deicer fluid tanks are fairly common once a car is of a certain age. A good remedy — until you can buy a new tank or find one at the junkyard — is to insert a plastic freezer bag into the tank and fill it with the washer fluid.
29. Don’t try to carry too much
Never exceed your car’s roof load specifications or weight limits.You can find them in your vehicle owner’s manual. Check the weight limitation of your roof rack as well. Typically the range is from 150 to 200 pounds (68 to 90 kg). That’s the equivalent of eighteen 8-foot 2 x 4s (2.4-meter 38 x 89s) or three sheets of 3/4-inch (17-mm) plywood. If you have to deliver a heavy load from the home or garden center, consider having it delivered. It will save wear and tear on you as well as your car.
30. Keep an old blanket handy
Protect your car’s roof from scratches with an old blanket before tying lumber, bicycles, or luggage to your roof rack.
31. Secure loads to avoid dents and scratches
The beginning of the end for the finish on many cars and trucks — and for wagon and hatchback interiors for that matter — is an improperly stowed load. Invest in the appropriate racks for bicycles, cargo, and luggage. A good trick to keep tall objects from sliding around in a pick-up truck bed is to use a shower curtain rod (or two) as a brace. Just push the cargo against the front wall of the truck bed and install the rod behind it. Twist to secure. Cargo nets will also help keep objects from banging around and damaging a truck bed.
32. Inspect wheel-well splashguards
These guards, however flimsy on many of today’s cars, help keep water and winter’s salty slush from splashing up into the engine compartment, where it can damage sensitive electrical components. Unfortunately, these guards tear off easily — sometimes without the driver knowing it. Check for damage to these guards when you wash your car. Re-secure with the appropriate fasteners or replace as needed. As added protection from splashed-up muck, slush, and debris, install mud flaps (also called splash guards) on your vehicle.
33. Wash in winter, too
If you rarely wash your car during messy winter weather, you are not alone.The cars you see on the road make it obvious that lots of folks figure,”Why bother? The car is going to look awful the next time I drive it.” The problem with this thinking is that washing is more important in the winter than other times of the year. All that sand, slush, and ice mixed with road salt is exactly what makes your car rust.The fastest corrosion occurs when the temperature repeatedly rises above and then falls below freezing. Especially during the messy months, be sure to rinse the undercarriage and hard-to-reach areas that are susceptible to rust, such as the bumpers and inside the wheel wells. If the temperature outside is going to stay above freezing long enough for your car and driveway to dry, fill a bucket with warm water and tackle the job at home. If not, pay a visit to your local car wash and be sure they dry the car thoroughly.
34. Wax to protect your car’s paint job
No way around it! Waxing your car is work. But it’s satisfying work that will help keep your car looking new. Car wax preserves paint by slowing oxidation and forming a barrier against bird droppings, sap, and pollution. Plus driving a nice shiny car is just plain fun.
Here’s what to do to ensure the maximum in protection:

• Liquid and spray waxes are tempting to use — they make the car shiny with less work than rubbing in paste wax. But there’s still no beating paste wax for the hardest, longest-lasting finish. Look for paste with a high carnauba wax content.
• Apply a thin, even coat of wax to the car’s surfaces with a damp sponge. Avoid applying too much, or it will be difficult to remove and some residue will inevitably mar your finish.
• To avoid fine scratches, use a clean, soft cotton or microfiber cloth to remove wax once it has dried.
• Apply an extra coat of wax to the nose and hood. The wax film in these areas wears away quickly.

35. Give your car a new skin
New self-adhering urethane films have been developed to protect the most vulnerable painted areas on your car from stone chips and other minor abrasions.You can wash and wax these surfaces, just as you would the rest of the paint job. While it’s best to have these films professionally installed, you can peel them off yourself. One product is made by 3M, and you can learn more by going to 3m.com and searching for Scotchgard Paint Protection Film Solutions.
36. Don’t let tools mar your car’s finish
If you plan to service and make repairs to your car, invest in a fender cover. It drapes over your fender, providing a safe place to rest your tools without causing scratches. It will also prevent your belt buckle from marring your paint as you lean into the engine compartment to work.

Tires, Wheels, and Brakes
37. Keep the caps on
You step out into driveway ready to start your morning commute only to discover a flat tire. How in the heck did that happen overnight? If the tire valve is missing its cap, the culprit might be a leaky valve. Those little caps keep out dirt and moisture that can cause leaks, so be sure to keep caps on all your tire valves. Another tip: When you replace tires, remind the tire shop that you expect new valves with the tires.
38. Maintain proper inflation
Under-inflated tires are a tire salesman’s best friend. They create excessive heat and stress that can lead to tire failure. If you want to get every last mile out of your tires, get yourself a tire pressure gauge and use it at least once a month (more in hot weather) to keep your tires inflated to the recommendation in the vehicle’s owner’s manual. Check tires when they are cold (driven for less than one mile) for an accurate reading.
39. Beware the wet thumb
If you top off your tires at a service station, check to see if there’s moisture coming from the air pump. Simply depress the pin inside the inflator valve with your thumbnail. If your thumb gets wet, advise the station manager that his tanks need to be drained and go to a different station. Moisture, trapped inside a tire, can cause pressure variations and corrode rims.
40. Check for uneven wear
Check tires for uneven wear. If you’ve maintained tire inflation properly, uneven wear may indicate the need for a wheel realignment. It can also mean improperly operating brakes or shocks, a bent wheel, internal tire damage, or worn bushings.
41. Check tread for safety
Most states require tires to be replaced when they have worn down to 1/16-inch (1.5 mm) of remaining tire depth. Tires sold in North America are required to have “wear bars” molded into them to make it easy to see when tire replacement is legally required. However, if you’ll be driving in the rain, you should change your tires when there is 1/8-inch (3 mm) of tread left. Otherwise, water may not escape from under your tires fast enough and you risk hydroplaning — a dangerous situation in which your car loses traction and literally floats on the water. Stick an American quarter between the treads in several places. If part of Washington’s head is always covered, you have enough tread to drive in the rain. If you drive in snow, you’ll need at least 3/16-inch (5 mm) of tread to get adequate traction. Stick an American penny between the treads. If the top of the Lincoln Memorial is always covered, you’re ready for winter driving.
42. Rotate your tires
Rotating your tires helps to distribute tire wear evenly and ensures that you’ll get the maximum road life out of them. The first rotation is especially important.Your owner’s manual should specify both rotation period and pattern. If not, rotate your tires every 6,000 to 7,500 miles (9,700 to 12,000 km) — your tire dealer should know the correct pattern of tire rotation.
43. When temperatures affect tire inflation
When outside temperatures drop or soar, tires tend to lose pressure. A drop of 10 degrees F (6 degrees C), in fact, will decrease a tire’s air pressure by 1 or 2 pounds.Tires can lose even more air in hot weather. Under-inflated tires can result in accelerated wear and poor driving performance. If you live in a place where temperatures vary a lot, check your tire pressure often and add air as needed.
44. Buy used tires
If you own a car that you plan to drive only for another year, the last thing you want to do is to buy a new set of tires. If it’s time to replace those tires though, it’s really time. Rather than hesitate, buy a set of used tires. Call local tire dealers to see what’s available. You’ll be surprised by how much wear is left in tires that are turned in by image-conscious car owners. Have your tire size handy.
45. Use wheel cleaner
Your car’s wheels are down there on the road, taking the brunt of road dirt. Add in the dust that wears off your brake pads and you’ve got a formula for stains that are tough to remove when you wash your vehicle. Car-washing liquid won’t do the job.You need a wheel cleaner specifically formulated to remove such stains. Be sure to buy the correct formulation. Some cleaners are designed for metal wheels, and others for painted or clear-coated wheels.The metal wheel cleaners come in various formulations as well, depending upon whether your metal wheel has a satin, aluminum, or chrome finish. Protect metal wheels with wheel polish, painted wheels with a coat of wax.
46. Lube your lug nuts
Lug nuts, if not lubricated occasionally, can seize or “freeze” to the studs due to corrosion. Repairing them can be expensive. Having to call a tow truck for a flat you can’t remove is even more expensive.The next time you change or rotate your tires, pick up some anti-seize lubricant at your local auto supply store. Clean the stud threads with a wire brush and wipe them with the lubricant. It’s formulated to prevent the lug nuts (spark plugs, too) from seizing and won’t allow them to loosen as you drive, the way other lubricants might. If a lug nut does freeze to a stud, try spraying the nut and stud with WD-40 or Liquid Wrench. Allow it to penetrate for 10 or 20 minutes. Use a heat gun to apply heat.Then use a ratchet wrench to remove the lug.
47. Hang on to your hubcaps
Clang, clang, clang! There goes your hubcap,rolling off to destination unknown. Hubcaps, wheel covers, and center caps can pop off your car’s wheels as you’re driving if they were not reinstalled correctly, have loosened over time, or if they were damaged by being jammed against a curb while parking. Here are some things you can do to keep these expensive parts on the car:

• If your older metal hubcap has loosened, remove it and pry the metal clips outward slightly. This should fix the problem.
• Newer plastic-type hubcaps and some wheel covers are usually held in place by a retaining wire ring that snaps into tabs on the wheel. When installing such a cap or cover, take care that you do not bend or break the tabs.
• One way to make sure your expensive hubcaps aren’t damaged by a repair shop is to remove them yourself before taking your car in for a repair that requires wheel removal, such as a brake job or new tires. When reinstalling hubcaps, rest the hubcap in place and then tap it gently with a rubber mallet. Don’t hit the hubcap hard, or you might break the clips underneath. If you prefer to have your repair person remove the covers, check to make sure they were reinstalled properly.They should look even and flush.

48. Have wheel alignment checked
Have your car’s wheel alignment checked every 30,000 miles (48,000 km), or as recommended in your owner’s manual. Also have it checked after buying new tires and when you replace a rack-and-pinion steering unit or other steering parts. Improper tire alignment will shorten the life of your tires as well as cause poor handling. If your steering is stiffer than normal or the vehicle pulls to one side, you probably have an alignment problem.
49. Top off your brake fluid
Check brake fluid monthly.Wipe dirt from the master cylinder lid before you open it. If you need fluid, add the type recommended by your car’s maker. Never substitute other fluids, such as transmission or power-steering fluid. And don’t use brake fluid from a previously opened container. Once exposed to air, brake fluid absorbs moisture and contaminates easily.
50. Care for anti-lock brakes
An anti-lock brake system is sensitive to moisture, which can ruin the expensive ABS pump and rot the brake lines from the inside. Since brake fluid attracts moisture, it should be “bled” or purged at least every three years, or as specified in your owner’s manual.